Product ID:PHILLYCLAD 6470 RESIN
MSDS Date:06/16/1988
FSC:8040
NIIN:00N025603
Kit Part:Y
MSDS Number: BMCPN

ITW-PHILADELPHIA RESINS CORP

130 COMMERCE DR
MONTGOMERYVILLE, PA 18936
US

Emergency Phone: 215-855-8450

Info Phone: 215-855-8450

Cage: IO181

ITW PHILADELPHIA RESINS

MONTGOMERYVILLE, PA 18936 US

Telephone: 215-855-8450

Cage: IO181

EPOXY RESIN, DIGLYCIDYL ETHER OF BISPHENOL A; (DGBA EPOXY

CAS: 25068-38-6

RTECS: SL6475000

TITANIUM OXIDE; (TITANIUM DIOXIDE).

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

KAOLIN

CAS: 1332-58-7

RTECS: GF1670500

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 2 MG/M3 TDUST; 9293

LD50 LC50 Mixture:SEE INGREDIENT 1
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN: RESIN IS MOD IRRIT & MAY CAUSE
SENSIT. EYES: MOD IRRIT TO EYES. CORNEAL DMG UNLIKELY. INHAL:
BECAUSE OF VERY LOW VOLAT, PROD IS NOT LIKELY TO PRDC ANY ADVERSE
EFTS BY INHAL. ITEMS 2 & 3 ARE NOT FREE TO BECOME AIRBORNE, INHAL
HAZS OF FILLERS WILL ONLY APPLY IF & WHEN "CURED" RESIN IS
GROUND/MACH TO (SUPP DATA)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:IRRITATION AS NOTED. SKIN SENSITIZATION
(ALLERGY) MAY BE EVIDENCED BY RASHES, ESPECIALLY HIVES.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN ALLERGIES MAY
INCREASE THE CHANCE OF DEVELOPING INCREASED ALLERGY SYMPTOMS FROM
EXPOSURE TO THIS PRODUCT. PRE-EXISTING SKIN & EYE DISORDERS MAY BE
AGGRAVATED BY EXPOSURE TO PRODUCT.

First Aid:EYES: IMMED FLUSH EYES W/PLENTY OF H*2O FOR AT LEAST 15 MINS
WHILE HOLDING LIDS OPEN. GET MED ATTN. SKIN:IMMED REMOVE CONTAMD
CLTHG. WIPE EXCESS FROM SKIN & FLUSH W/PLENTY OF WATER FOR AT LEAST
15 MIN S. USE SOAP IF AVAIL/FOLLOW BY WASHING WITH SOAP & WATER. IF
EFTS OCCUR/PERSIST GET MD ATTN. DO NOT REUSE CLTHG UNTIL THORO
CLEANED. LEATHER ARTICLES INCLUDING SHOES CANNOT BE DECONTAMD (SUPP
DATA)

Flash Point Method:COC
Flash Point:437F,225C
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE KNOWN.

Spill Release Procedures:AVOID PERSONAL CONTACT. SCRAPE UP AS MUCH
MATERIAL AS POSSIBLE AND PLACE IN A SUITABLE, LABELED, CONTAINER
FOR WASTE DISPOSAL. RESIDUE MAY BE REMOVED USING A SAFETY SOLVENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN COOL, DRY PLACE WITH ADEQUATE
VENT. KEEP AWAY FROM OPEN FLAME AND HIGH TEMPERATURES. AVOID ALL
SKIN CONTACT & BRTHG OF VAPORS.
Other Precautions:HANDLE IN ACCORDANCE WITH THE HAZARD POTENTIAL OF
CURING AGENT. PRACTICE GOOD HOUSEKEEPING PROCEDURES.

Respiratory Protection:NOT ORDINARILY REQD FOR RESIN. RESP PROT SHOULD
BE SUITABLE FOR ALL WORKING CNDTNS ON JOB. DUST MASKS SHOULD BE
WORN DURING ANY GRINDING/MACHINING PROCS ON CURED RESINS.
NIOSH/MSHA APPRVD ORGANIC RESP S MAY BE REQD IN CONFINED AREAS.
Ventilation:GENL:GOOD GENL VENT IS USUALLY ADEQ FOR MOST INDUST
APPLIC.LOC EXHST:SHLD BE USED IN CONFINED AREAS/WHERE VAP(SUPP
DATA)
Protective Gloves:CHEM RESIST OF IMPERVIOUS RUBBER/PLASTIC
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:WEAR CLEAN LONG LEG AND SLEEVED CLOTHING.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING, AND BEFORE
SMOKING, EATING OR USING TOILET FACILITIES.
Supplemental Safety and Health
HLTH HAZ: PRDCE DUST. INGEST: RESIN IS GENL CONSIDERED TO HAVE LOW
ORDER OF ACUTE ORAL TOX. FIRST AID PROC: & SHLD BE DESTROYED.
INHAL: REMOVE VICTIM TO FRESH AIR & PROVIDE O*2 IF BRTHG IS DFCLT.
GET MED ATTN. INGEST: DO NOT INDUCE VOMIT. IMMED SEE MD.
VENT:CONCS EXCEED ESTABLISHED TLV'S.

HCC:N1
Boiling Pt:B.P. Text:530F,277C
Vapor Pres:<0.01 @20C
Spec Gravity:1.18
Evaporation Rate & Reference:NON-VOLATILE
Solubility in Water:SLIGHTLY SOLUBLE
Appearance and Odor:WHITE LIQUID, NON-OBJECTIONAL CHARACTERISTIC ODOR.
Percent Volatiles by Volume:0

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS AND STRONG LEWIS OR MINERAL ACIDS.
Stability Condition to Avoid:CONSIDERABLE HEAT CAN BE RELEASED WHEN
REACTED WITH UNCONTROLLED AMOUNTS OF CURING AGENT.
Hazardous Decomposition Products:AS WITH ANY OTHER ORGANIC MATERIAL,
COMBUSTION WILL PRODUCE CO*2 AND PROBABLY CO AS WELL AS ALDEHYDES
AND ACIDS.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.